Author Topic: Advice please. Hints tips , how to gcode a 1/4 turn helix on a shaft  (Read 3551 times)

Offline Stuart

  • Full Member
  • ****
  • Posts: 1750
  • Tilchestune UK
Re: Advice please. Hints tips , how to gcode a 1/4 turn helix on a shaft
« Reply #15 on: February 27, 2016, 05:09:38 PM »
Chuck

My bad the answere was given in one of the links by John Stevenson MBE ( he says it motor bike engineer )

I should have updated this to say so

But thanks for posting as is my want I copy these snippets into a file for future reference

When I start the actual job I will post the result

Stuart
My aim is for a accurate part with a good finish