silver bullet drawings

[sid pileski]

Hello all. Maybe I'm not in the right place to post this, but, here goes.

I bought a set of castings and plans from Bob Shores years ago. I have the engine built up to the point were I needed an ignition
setup for it. Then, it went on the shelf.
That was probably five years ago. I decided to buy a CDI unit from S/S engineering. I received it and it looks like a nice set up.

My problem is, I can't find my set of drawings!! I have the packet of information that came along with the castings, including
all of Bob's whimsical advice on building the engine.

So, where can I get a replacement set of drawings? I know Bob passed years ago.

Any help would be greatly appreciated.

Thanks, Sid

[tvoght]

Hi Sid,
Castings sets are now available from:

http://www.modelenginecastings.com

It's not clear if they'd sell just the drawings, but it's certainly worth making contact.

Hope this helps,
--Tim

[sid pileski]

Thanks, I'll look into what they offer.

Sid

[sid pileski]

I did contact them, and my plans are on the way.

Thanks again, Sid