Hello all. Maybe I'm not in the right place to post this, but, here goes.
I bought a set of castings and plans from Bob Shores years ago. I have the engine built up to the point were I needed an ignition
setup for it. Then, it went on the shelf.
That was probably five years ago. I decided to buy a CDI unit from S/S engineering. I received it and it looks like a nice set up.
My problem is, I can't find my set of drawings!! I have the packet of information that came along with the castings, including
all of Bob's whimsical advice on building the engine.
So, where can I get a replacement set of drawings? I know Bob passed years ago.
Any help would be greatly appreciated.
Thanks, Sid