2016 N.A.M.E.S. Expo, info flyer

[PTsideshow]

With gas heading back to the good ole days, It's time to make plans for the 2016 N.A.M.E.S. Expo, whether as an exhibitor or vendor.

[PTsideshow]

Time to get your motel reservations

[PTsideshow]

Everything moving along toward the show dates and vendors booths filling up.

[PTsideshow]

It's getting down to crunch time, For the vendors as of Saturday only one space was left.

[sshire]

Can't wait. Reservations made. Engines polished.

[PTsideshow]

Have a safe trip! Looking forward to see you again.

[sshire]

Who else is going?
A MEM table like last year would be nice.

[tvoght]

Stan,
I'll be there, and it would be nice to sit with others from the group. This is as good a place as any to ask: what fitting do I need to hook up to an air valve at the table? I believe it's 1/4 NPT, but what gender? I still hope to have my Roberts Mechanism steam engine running by then, and I have acquired the trick regulator setup that you (Stan) use, the SMC ARM1000.

--Tim

[gldavison]

I plan too be there also.

Stan you started something there, I also acquired one of those regulators.

Get the banner up.

[PTsideshow]

The fitting on the manifold are 1/4" petcocks with the female end facing user end. Stan plant the Banner and stake out some space it would be helpful for him to know how many will be there under the MEM banner.

[jeff l]

I plan to go .

[Art K]

Stan,
I plan to be there. Looking forward to seeing everyone again.
Art

[tvoght]

The fitting on the manifold are 1/4" petcocks with the female end facing user end. Stan plant the Banner and stake out some space it would be helpful for him to know how many will be there under the MEM banner.

Thanks!

--Tim

[RonGinger]

I am planning to be there, only missed #1 because I did not know about it but have made it every other year. It is just about a 2000 mile round trip for me, and for 26 years that is about 56,000 miles I have driven to be there. How is that for a crazy thought?

I will be doing my nearly annual talk "Adventures in home shop CNC" on Saturday at 10:30. Hope to see a bunch of you there. I will be reporting on the new CNC lathe conversion I am doing for theCNCworkshop.com. We plan to have the proto model there running.

[kvom]

I plan to be there as well, although unsure if I'm going to drive or fly.  I'm definitely interested in the CNC lathe conversion project.