Author Topic: Atkinson pictures and specs?  (Read 1741 times)

Offline Myrickman

  • Full Member
  • ****
  • Posts: 264
Atkinson pictures and specs?
« on: November 21, 2015, 12:36:12 AM »
Picked up a copy of the Atkinson model made by Joe T  from a guy on enginads. Was curious if anyone has good clear pictures of the finished model. How big are the flywheels? I'm guessing about 6 inches. Always wanted to make this engine. I should be getting the castings in about a week. I was going to work on some of the full sized engines I am restoring but you know the drill....gotta have it. Apparently Joe passed away and these were remaining kits from his estate.  Paul

Offline Jasonb

  • Full Member
  • *****
  • Posts: 9463
  • Surrey, UK
Re: Atkinson pictures and specs?
« Reply #1 on: November 21, 2015, 07:44:32 AM »
There was a guy on HMEM that picked up a lot of his stock of castings which may be where yours came from, if not then could be worth contacting him.

http://www.homemodelenginemachinist.com/showthread.php?t=9486

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal