Author Topic: james coombes.  (Read 10760 times)

Offline Roger B

  • Global Moderator
  • Full Member
  • *****
  • Posts: 6133
  • Switzerland
Re: james coombes.
« Reply #30 on: September 16, 2015, 06:11:58 PM »
Well done  :praise2: A runner is always good  :ThumbsUp:  :ThumbsUp:
Best regards

Roger

Offline kellswaterri

  • Full Member
  • ****
  • Posts: 153
Re: james coombes.
« Reply #31 on: September 16, 2015, 09:53:01 PM »
Yes Jo,  it is both auto and manual focus ...i had  it set on manual with out checking ,it was mounted on a tripod behind me and i had to use a mirror to see what was on the screen,then switched over to auto ...U tube did a pretty good  job of tidying up my efforts ,...thanks U TUBE...i have just ordered some grub screws in BA  sizes...and am realizing that  BA material is almost a bad word to traders ...I could obtain a box of 200 easily enough 30 of them ...different story same with silver steel rod ...It is rather costly investing in new metric tooling.
                           cheers,
                                      John.   (Kellswaterri)

Offline kellswaterri

  • Full Member
  • ****
  • Posts: 153
Re: james coombes.
« Reply #32 on: September 21, 2015, 03:36:54 PM »
S.O.S.####
                 Spent about 3 hours on the net , trying to obtain   NO 5BA...grub screws steel   allan key type could anyone tell me of a stockist or spare me a couple,,,the occilator sheave keeps slipping as those ruddy slotted ones are not up to holding. :Mad:
all the best ,
                  Kellswaterri   John.



Online Jasonb

  • Full Member
  • *****
  • Posts: 9466
  • Surrey, UK
Re: james coombes.
« Reply #33 on: September 21, 2015, 03:43:37 PM »

Offline kellswaterri

  • Full Member
  • ****
  • Posts: 153
Re: james coombes.
« Reply #34 on: September 25, 2015, 10:53:43 PM »
Hi Jasonb...just obtained some no 4   and no 5   grubs                                                                                                                                                 
          cheers,
                        John.

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal