Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Looking good Don, the over run won't be covered but a simpler fix may be to just widen the slot as there is nothing sitting on that side of the base.
Hi DonMan that is some nice work; I was wondering what the extra material was for on the ends of the top plate now I see why.So what is the draft angle of the sides on that base casting? Have a good trip,Dave
Very nice work on the base Don. If the little notch is noticeable just take a piece of round stock and cut a disc from it to match the diameter of the cutter then just soft solder it in place. I hate having to silver solder a part after all the machining is done. (too much cleanup).gbritnell
Nice work Don , done that a few times in my time though so swear by setting table stops to prevent it - as everyone agrees though you have several options to disguising it.Apart from that it's a nice clean up from a silver soldered build up - shades of what's to come I'll wager.Regards - Ramon
Nice detail work on that Don. It should finish up beautifully and be a fitting base for this fine engine!!Bill
Hi Don, good to see your wood work and also the wood milling machine. I didn't now, that German wood milling machines from Bosch have found their way to LA also.