Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Jo, didn't you make headstock oilers for one of yours? Was that the high speed mod you refer to?
Quote from: ths on September 01, 2014, 09:25:46 PMJo, didn't you make headstock oilers for one of yours? Was that the high speed mod you refer to?Yes I made drip oilers for C1, which allows me to work for longer without having to add a drip of oil every 20mins or so which is much better. But I do have to watch I do not knock the oilers off when I use the chuck key. The later machine has flippy cap oilers, they do not hold as much oil but more than adequate for most normal operations. But they redesigned the entire headstock on the later machines, the headstock cast was a bit thin either side of the bearings so they squared them up adding much more material. Jo
AS,STOP right there. This is taking up far too much time as it is .
Quote from: tangler on September 04, 2014, 03:53:23 PMAS,STOP right there. This is taking up far too much time as it is .<sigh> So typical of the youth of today - no time to do the job properly. Now a REAL engineer would be taking moulds from the headstock and digging a mine in the garden to mine the ore from which the iron will be extracted to cast into those moulds. That's the way we'd have done it when *I* were a lad, but these days everyone just wants the instant solution... AS
It doesn't look like the outrunner idea is going to work just at the moment - food for thought though, thanks AS.