Author Topic: MEM Banner  (Read 1254 times)

Offline sshire

  • Full Member
  • *****
  • Posts: 3043
    • LS Editions
MEM Banner
« on: April 23, 2014, 08:23:14 PM »
Sometimes, I get a thought that would have been good about a week ago.
The 6' MEM banner that we used at Cabin Fever could have been used at NAMES. I could have given it to Ron Ginger to transport.
So here's the deal. Any member who would like to use the banner (poles not included) for a show need only PM me. I'll ship one way; you ship it back.
We had it bungeed between 2 poles but it could also rest on a table. It's vinyl so engines could be on it as oil will wipe off.
Best,
Stan

Offline AussieJimG

  • Full Member
  • ****
  • Posts: 450
  • Bywong, NSW, Australia
Re: MEM Banner
« Reply #1 on: May 21, 2014, 11:00:38 PM »
Hi Stan,

We are looking to have an MEM table at the Melbourne Model Engineering Exhibition on 4/5 October 2014 and I was thinking about a banner similar to  yours.

If it can be shipped over here, that would be good. Alternatively, how did you make it? I might be easier to have one made here.

Regards

Jim

Offline sshire

  • Full Member
  • *****
  • Posts: 3043
    • LS Editions
Re: MEM Banner
« Reply #2 on: May 22, 2014, 02:24:27 AM »
Jim
The banner was made at a signs-in-a-day shop. Since the guys are friends, they went all out. Double-sided vinyl, stitched edges and grommets. I'm guessing they're about $50.00 USD.
Let me know if you want me to send it.
Best,
Stan