SpotOn / Verdict DTI repair

[tangler]

Over in "Chatterbox - Please Join In" Baron was asking about the replacement adjustment levers I have on my gauges.

I bent these up from copper alloy sheet of some sort.  It could have been beryllium copper or phospher bronze, it was a long time ago.  Anything half hard or better will probably do - it just needs to have a bit of spring in it.  Steel package strapping would probably do the job.  Here's a few pics.







Hope this helps,

Rod

[BaronJ]

Hi Rod,

Ahh, I see that you did something similar to me.  Only yours are a lot prettier than mine. :-)