Author Topic: SpotOn / Verdict DTI repair  (Read 2045 times)

Offline tangler

  • Full Member
  • ****
  • Posts: 779
  • Christchurch, UK
SpotOn / Verdict DTI repair
« on: April 10, 2014, 12:29:00 PM »
Over in "Chatterbox - Please Join In" Baron was asking about the replacement adjustment levers I have on my gauges.

I bent these up from copper alloy sheet of some sort.  It could have been beryllium copper or phospher bronze, it was a long time ago.  Anything half hard or better will probably do - it just needs to have a bit of spring in it.  Steel package strapping would probably do the job.  Here's a few pics.







Hope this helps,

Rod

Offline Baron

  • Full Member
  • ****
  • Posts: 137
  • Grumpy Old Git !
Re: SpotOn / Verdict DTI repair
« Reply #1 on: April 10, 2014, 09:04:40 PM »
Hi Rod,

Ahh, I see that you did something similar to me.  Only yours are a lot prettier than mine. :-)

Best Regards:  Baron.

I donít regret the things Iíve done, I regret the things I didnít do when I had the chance.