Potty Vertical Cross Single

[rarach22]

Hi, Realy nice work, beautiful model... Pavel

[NickG]

Nice work lot of bits there!

[Mike Bondarczuk]

Hi Stew,
Have been reading your build for this cross engine and would really like to receive a set of drawings.
If you could forward them to [removed Email address] then that would be most appreciated.
With thanks and best regards,
Mike

Jo's edit: Mike I have removed your email address for your own security. Please send Stew your Email address via a PM rather than openly on the forum.

[Jim Nic]

Roy (Wheeltapper)
I have just started my version of this engine.  I was impressed by your stack of bits, did you get it running?
Jim

[Jim Nic]

We have another runner!    
Hopefully a couple of pictures of my interpretation of Stew's engine have appeared below.
It was a good engine to build and runs smoothly at a nice slow speed with plenty "going on" as it were.  As can be seen there is plenty of scope for personalisation.  Thanks for the design Stew.
It is one of Stew's "beginners" series of designs and I have no hesitation in recommending it as perhaps a third project after a wobbler and the horizontal mill version. 
Jim

[sbwhart]

Well done Jim

 it looks a cracker   

I like the bits of additional embellishment 

Stew

[Roger B]

Looks splendid    Do you have a video?

[b.lindsey]

I like it Jim...very well done indeed. Yes a video would be nice too when you can.

Bill