« previous next »
Pages: [1]   Go Down

Author Topic: Quick Centring of a Rotary Table  (Read 3749 times)

Offline BillTodd

  • Full Member
  • ****
  • Posts: 531
  • Colchester UK (where the lathes were made)
    • Bill's website
Quick Centring of a Rotary Table
« on: July 24, 2012, 09:32:14 PM »
I use a cheap centre finder with an adapter to fit the centre of the Rotab.

The mill is off/stationary (important !). The centring is either by touch or eye, either will get you to within a thou" or so



Logged
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal