I decided to make one of these for my little Pultra lathe, it is a design that I have seen elsewhere and just modified a few dimensions to suit my application.
Actually I made a few sets whilst I had the machines set up, so what you see is enough parts for four of them on the go. Some of these may end up on ebay soon.
1¼" square blocks marked up for drilling etc
Machining the dovetails on the tool holder material.
My prefered method of measuring dovetails.
Reducing tool holders to finished height on the shaper.
Making good progress now.
Cutting the slot for the tool bit with 1/4" side and face cutter.
Slitting the main block with a 1/16" slitting saw
Finally finished.
Phil