Hi
Thanks Roger.
I needed a couple of bolts for the eccentric so today I made a couple. Start with 2 studs made from 3/32 stainless steel.
Screw on 2 steel nuts
Silver solder
Clean up
Fitted in the eccentric. I will fit locking half nuts on final assembly
Moving on to the piston. About 6 months ago I bought a piece of cast iron bar to make the piston. Could I find it.
yes after about 2 hours of searching, what a waste of a rare saturday afternoon in the workshop
The piston rod is 5/32 stainless steel.
The elusive cast iron turned to size and drilled and tapped
The piston rod is held in the tail stock chuck to ensure correct alignment. A drop of loctite on the thread and the 2 parts screwed together.
Cut a ring groove and part off
Face and size the piston
Cheers
Rich