Author Topic: Tailstock Die holder  (Read 14444 times)

Offline Ian S C

  • Full Member
  • ****
  • Posts: 1067
  • Stirling Engine Maker Darfield Canterbury N Z
Re: Tailstock Die holder
« Reply #30 on: July 19, 2013, 02:06:09 PM »
I got two holders in a job lot at an auction a good many years ago, the have hollow parallel shanks on them, so I hold them in the Jacobs chuck, and they have just two diametrically opposed grub screws, they seem to work ok,   one is 1" size, and the other is a size smaller, can't remember what that is.   Ian S C