Author Topic: Mill/Drill Stand  (Read 3083 times)

Offline RMO

  • Full Member
  • ****
  • Posts: 126
  • Rexburg, Idaho, USA
Mill/Drill Stand
« on: August 13, 2012, 07:13:45 PM »
I have a Jet round column mill/drill that works fine, but I am somewhat concerned about the stand that it came with.  As you can see the stand is made of aluminum pipe with a couple of boards across the top with the Mill on top of that.  I have notice a bit of vibration and have been thinking a stouter stand or base might be in order.   The current stand is also a bit wide.  I would love to hear recommendations or perhaps see some pics of what you are using to hold up similar type machines.

Mike O

 

SimplePortal 2.3.5 © 2008-2012, SimplePortal