Help! > Machines, Tools and Fixtures
Small Boring Head
steamer:
OK.....done!
I'll let you know what it looks like....
Dave
steamer:
Got a Albrecht chuck to go with the boring head....short 3/8 shank...though I may make it even shorter...
This will be easier to get in and out of position Mosey while centered over a workpiece...than a whole W12 shank...and going to a straight shank, I can use it on either the Aciera or the Clausing...so I don't have duplicate tooling.....
0-3/16"...should be plenty big enough for the Aciera...I have a larger set of chucks for the Clausing.
Good match I think
Dave
Jo:
That's sweet ;D.
Jo
steamer:
Isn't it though?
too nice to pass up ...so I snagged it.....thank you ebay.
Saw a couple of nice looking F1's Jo....it's not too late! :mischief:
Jo:
Yes but you mentioned the idea of a super model chatting me up, now I might have to re-prioritise my naughty list :embarassed:
Jo
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version