Welcome to ModelEngineMaker !If you have problems registering or logging in, please use the contact menu option to request assistance.
Hello Ramon. I'm working on my McOnie's and have the baseplate, frames and pedestal blocks completed apart from the bearing bushes. Now comes the crankshaft and was thinking of making it your way as the method using the flame cut plate is not very good. What tolerance did you use for the clearance between the shafts, crank pin, and the webs in order for the Loctite to work properly ?I take it that you have finished yours, a picture would be much appreciated. Can I contact you directly by email for any further queries ?Mike Malleson.
Regrettably my engine is still not finished though has progressed considerably since last posting. I am hoping to at least get the inlet side of things done so I can run it on air at this years Forncett ME Day in October.