Introduction.

[John S]

Hi all, member of MM and used to be on HMEM until the recent upheaval but enough said about that.

Had a bit of problem signing up, you had to fill the missing word in, the clue was Bridgeport ??? Machine.
As I have one of these that I'm closely attached to  I filled the missing letters in as POS but wouldn't let me sign in for some reason ??

Don't build model engines, just don't have the time but am always intersted in seeing other work and if I can helpon machining advise or CNC then very happy to do so.

[Bogstandard]

Hi John,

A very big welcome to yourself and all your knowledge, I'm sure that over time, lots of people will benefit from your expertise, even though it isn't little engine orientated.

John

[mklotz]

Damn, there goes the neighborhood.  Allowing Geordies in, what's next?  Texan doomsday preppers?

Seriously, we're glad you're here.  Every forum needs a bad example.

[Dan Rowe]

what's next?  Texan doomsday preppers?

Marv,
I really hope not that guy lives about 20 miles due south of me and I really doubt that it is ground zero for the US or even Texas.

Dan

[tel]

Good to see you land here John

[MrSleepy]

Did you work out a solution to your knee drive for the pos..

I'm not sure if you saw my offer of a pcb to interface a joystick/pot to a vfd.

Rob

[fcheslop]

Marv, depends wether they are makems or takems in geordie land marra

[John S]

Rob, saw it but have got side tracked, work has gone haywire this week. Was planning to play today and see how easy it was to get the motor fitted but didn't happen, Jog my memory was it on MM or HSM ? I'll PM you from there

[MrSleepy]

On HSM.

Rob.

[Dean W]

Glad you are here, Sir John. 

[Pete49]

Now we can boast of having royalty on our board  Welcome Sir John of etc etc
Pete