compact 8 deviding head

[krv3000]

hi all this is rather a long post so Bear with me after a search on the net i did not find Wat i needed so i deiced my own on my lathe their is a gear wheel behind the mane drive pulley this is for the drive for screw cutting i had a worm drive that fitted so that was me starting point i had the shaft that the worm came from so i made the shaft shorter and moved the worm further up the shaft i then made the top and bottom bush for the shaft to run in then fitted them in to the outer tube i did not mack this this cam from a mug tree right pics

[tel]

Looks like an interesting project coming up - I'll be watching

[steamer]

Count me in buddy!

Dave

[Don1966]

I am always in on anything that looks interesting, count me in.

Don

[krv3000]

right next part was to mack the dividing plate this is made from 100mm DI stainless steel which i sawed a lump of then turned it up you will get the just by the pics as i made this sum time a go so i don't have the dimensions at hand and its too cold to sit in the work shop and mesher things up  i set one of the 4 fixing screws off so that the plate will only go on one way i then divided the plat up and drilled the holes for the detente right pics if you have any question's just ask

[krv3000]

right i mad up the bracket to fix it to the lathe out of-sum 4mm steel plate then the worm drive was silver soldered to it i made the bracket to hold the detente out of sum 8mm stock then put the lot together  pics

[Bogstandard]

Great project Bob, you are getting like me, making bits and pieces to help yourself in the shop.

I must take this opportunity to congratulate you on your progress to a full recovery. I remember when hardly anyone could understand what you wrote, but now, it is getting much better and easier to understand, a truly massive improvement.

Keep up the good work mate, you'll get there in the end.


John

[Don1966]

Nice work Bob, looks some what like my Hemingway Dividing attachment kit. I haven't had time to start machining it yet, but it attaches to the bull gear like yours.

Don

[steamer]

That's looking great Bob!

Dave

[ScroungerLee]

Nice job Bob, and a great idea.  Thank you!

Lee

[krv3000]

thanks all for the comments hi john yep i have improved  with my spelling as you remember that was one of the reasons for joining the forums to help my recovery and it has