« previous next »
Pages: [1]   Go Down

Author Topic: Internal gear broach  (Read 3226 times)

Offline Johnmcc69

  • Full Member
  • ****
  • Posts: 792
  • Erie Pa., USA
Internal gear broach
« on: November 24, 2012, 01:04:55 AM »
I was thinking about Elmers gear engine..
I keep hearing the $ of internal gears is spendy.Would
It be practical, to grind up a gear "broach" & make these gears
with  rotary/dividing head?

John
Logged

Offline tel

  • Full Member
  • ****
  • Posts: 1657
  • Bathurst District, NSW, Oz.
Re: Internal gear broach
« Reply #1 on: November 24, 2012, 07:55:49 AM »
Yes it would - that's how they are done on a shaper.
Logged
The older I get, the better I was.
Lacerta es reptiles quisnam mos non exsisto accuso nusquam
Pages: [1]   Go Up
« previous next »
 
SimplePortal 2.3.5 © 2008-2012, SimplePortal