The answers from both Roger and Steve are absolutely on the mark......progressive rotational force will shear the Loctite bond, '
then' shear the pin
One consideration here is the setup......it would be far earsier to drill, ream & glue the webs & pins and set them up & clamp them down in a true 90 degree relationship without a series of pins protruding through the components
After the glued components have the recommended cure time, then set up & complete the drilling & taper reaming for the pins
No amount of vibration or and cutting fluids will damage the bonds and the latter process will be far easier to complete
So effectively by gently tapping the taper pins will add a mechanical stress within the joint between web & pin joint
A little reading will confirm the load/gentle hitting force required for the insertion of each pin, however importantly, this now can be achieved over a holed anvil
I have spoken in this Forum about ...after trial fitting each pin, mark them, place them in a refrigerator freezer for a few hours, then taking out one at a time & insert + tap in..
Derek